Top

  1. Previous
    Next
    Product 1 of 30
    This product was added to our catalog on Saturday 22 December, 2012.

    .Aqua-Flo A-Series Pump Diagram

    Price:  

    Aqua Flo A Series Pump Diagram

    PRIMING PUMP

    At initial start-up, pump must be primed by filling hair and lint trap with water. To prime pump, remove cover from hair and lint trap: fill pump and suction trap with water. Replace cover (make sure the o-ring is in place) and tighten lock handles. Pump will now prime, with priming time depending upon lift and horizontal distance of suction piping.

    • CAUTION: Do not remove hair and lint strainer lid while pump is running or under pressure! Lid is held in place by lock handles which can be removed or tightened by hand. Basket must be kept clear of leaves and debris at all times.

    REMOVING BASKET

    1. Turn off motor.
    2. Remove lid.
    3. Remove basket and empty debris.
    4. Replace basket, fill with water, replace lid securely to prevent air from entering and tighten. DO NOT USE TOOLS.
    5. Turn on motor.
    6. Open air-relief valve on top of filter until steady stream of water comes out.

    NOTE: If pump is installed below water level of pool, close return and suction lines prior to opening hair and lint pot. Make sure to re-open valves prior to operating.

    DO NOT RUN PUMP DRY!
    Always maintain proper water level in pool. If water level falls below skimmer intake, pump will suck air. Pump is equipped with a maintenance-free, heavy-duty mechanical seal. Damage will occur if pump runs dry, and warranty will be voided.


    TO PREVENT FREEZING
    Drain liquid from pump through plug at bottom section of volute. It is recommended to apply a good rust inhibitor into liquid end to prevent corrosion.

    Be sure motor is kept dry and covered. In mild climate area, when freezing may occur, run pump and filter equipment continuously to prevent freezing.

    1 B121 MOTOR 3/4 HP motor a-series aqua-flo a.o. smith
    B120 MOTOR 1/2 HP motor a-series aqua-flo a.o. smith
    B122 MOTOR 1 HP motor a-series aqua-flo a.o. smith
    B123 MOTOR 1 1/2HP motor a-series aqua-flo a.o. smith
    B124 MOTOR 2 HP motor a-series aqua-flo a.o. smith
    B125 MOTOR 3 HP motor a-series aqua-flo a.o. smith
    2 92520000 V40-116 SHAFT EXTENSION shaft extension aqua-flo a-series, dominator pump
    3 99730000 V40-401 SCREW, SOCKET SET, 1/4”-20 X 5/16” pump shaft screw a-series dominator val-pak v40-401
    4 91140050 V40-460 BRACKET, 1/3-3 HORSEPOWER aqua-flo pump bracket brass val-pak
    91140100 V30-461 BRACKET, 1/3-3 HORSEPOWER
    WITH FOOT
    aqua-flo pump bracket brass val-pak
    5 99050030 BOLT, HEX MACHINE, 5/16”-18 X 5/8”  
    6 99050050 BOLT, HEX MACHINE, 3/8”-16 X 5/8”  
    7 91500059 G44 V40-115 VOLUTE GASKET volute gasket h&f
    8 92509040 PS-1000 SHAFT SEAL pump shaft seal ps-1000 aqua-flo dominator
    9 91691000 V40-452 IMPELLER 0.33 HP impeller pump aqua-flo val-pak a-series 0.33 1/3 hp v40-452
    91691052 V40-453 IMPELLER 0.5 HP impeller pump aqua-flo val-pak a-series 0.5 hp v40-453
    91691101 V40-454 IMPELLER 0.75 HP impeller pump aqua-flo val-pak a-series 0.75 3/4 HP v40-454
    91691201 V40-455 IMPELLER 1.0 HP impeller pump aqua-flo val-pak a-series 1 hp v40-455
    91691151 V40-456 IMPELLER 1.5 HP impeller pump aqua-flo val-pak a-series 1.5 hp v40-456
    91691251 V40-457 IMPELLER 2.0 HP impeller pump aqua-flo val-pak a-series 2.0 2 hp v40-457
    91691300 V40-458 IMPELLER 3.0 HP impeller pump aqua-flo val-pak a-series 3.0 3 hp v40-458
    10 92770200 Volute 0.33-2.0 HP, 100% Drain aqua-flo val-pak pump volute a series
    10 92770060 VOLUTE 0.33-2.0 HP aqua-flo val-pak pump volute a series
    11 91100100 PLASTIC BASE  
    12 99050110 BOLT, HEX MACHINE, 5/16”-18 X 1”  
    13 99890050 WA  
    14 92290000 PIPE PLUG  
    15 91500150 V40-118 G57 GASKET, TRAP, 5” trap gasket aqua-flo a-series pump g-57 5 in
    91500200 GASKET, TRAP, 6” AND 8”  
    16 92620000 TRAP, 5”, 1-1/2” SUCTION aqua-flo pump pot trap a series
    17 91110000 B-33
    V40-465
    BASKET, STRAINER, 5” aqua-flo aqua flo pamp a-series a series pump basket
    91110010 BASKET, STRAINER, 6” aladdin basket aqua-flow pump basket 6in b-34
    18 92200000 O-RING, TRAP COVER, 5” 5in cover o-ring pump aqua-flow a-series
    92200010 O-RING, TRAP COVER, 6”  
    19 91230000 V40-463 TRAP COVER, 5” brass lid 5 inch aqua-flo pump
    91230050 TRAP COVER, 6”  
    20 91920001 V40-468 LOCKHANDLE aqua-flo a-series pump lochhandle
    Reviews

Categories

Brands

Share Product

Share via E-Mail Share on Facebook Share on Twitter Share on Google Buzz Share on Digg

Manufacturer Info