Top

  1. Previous
    Next
    Product 41 of 60
    This product was added to our catalog on Saturday 22 December, 2012.

    Temperature 1K Sensor 4 Wire Jandy 4019
    [4019]

    Price:  

    Jandy Temperature 1K Sensor 4 Wire Replacement Kit for Ji/AquaLink 4019

    Installation Instructions

    1. Turn off all power to the Power Center and make sure the pump is not circulating.
    2. The location of the water temperature sensor is between the pump and the filter (see Figure
      below). Drill a 3/8" hole on top of the pipe between the pump and the filter.
    3. Insert the Water Temperature Sensor in the hole drilled in step 2. Use the clamp provided in the
      kit to keep the sensor in place.
    4. Run the Sensor's wire back to the Power Center.
    5. Inside the Power Center, remove the screws holding the PCB.
    6. Run the Water Temperature Sensor wire through a knockout in the bottom of the Power Center.
      Plug the connector into the WATER TEMP. SENSOR socket on the PCB. Use the wiring
      diagram on the inside of the door panel to locate the WATER TEMP. SENSOR socket.
    7. Replace the PCB Panel and the Dead Front Panel being careful not to pinch any wires.
    8. Restore power to the Power Center. Test the Water Temperature Sensor by turning the pump on
      and looking at the temperature display on the JI Series Control Panel.

    4019 or 5089 sensor installation instructions

    Reviews

Brands

Share Product

Share via E-Mail Share on Facebook Share on Twitter Share on Google Buzz Share on Digg

Manufacturer Info